(Solution) Xhorse chip crack failed! Error code: 13050001

This article will share the problem and solution of the Xhorse chip crack failure reported by our customer Michal Stecki.

Michal Stecki feedback:

I used vh23 Smelecom to write Xhorse chip and multi prog I have this from the screenshot

Solution:

The power setting was 5 v default for 160d change for 3.3 and it reads

Problem solved.

For more tech support, please contact:

Whatsapp: +86 13983755934

Telephone: +86 13983755934

Wechat: +86 13983755934

Official Email: Sales@obd2shop.co.uk

Skype: OBD2Tool.co.uk

www.obd2shop.co.uk

Fixed Xhorse Multi PROG Update and Language Change Issue

This article will provide solutions to two customer-reported issues: Xhorse Multi Prog update issues and how to change the screen language from Chinese to English.

1. Customer Dawid from UK

Hello, Xhorse Multi PROG It’s passed after a few attempts, sort it, please.

Solution:

Check the network to make sure in good condition,  Restart the device and try again.

Customer feedback:

Update success!

2. Customer Raj 27 motors from UK

How do I change the language on this device please, To English?

Solution:

enter into "系统设置" choose the "语言" setting as English, click "确认" then restart the machine.

Customer feedback:

Done, thank you

For more tech support, please contact:

Whatsapp: +86 13983755934

Telephone: +86 13983755934

Wechat: +86 13983755934

Official Email: Sales@obd2shop.co.uk

Skype: OBD2Tool.co.uk

www.obd2shop.co.uk

Xhorse Condor XC-002 PRO Cut HON66 Key Tutorial

Today we'll discuss cutting a HON66 key with Xhorse Condor XC-002 PRO. Before cutting, always make sure the key-cutting machine is well-calibrated.

Height Level Adjustment

Method 1. 

1)To start, we insert the original key with the help of a guiding block. We will use a shim to ensure the key is well-aligned.

2)Insert the key blank to the right. Now we're ready to begin height level adjustment.

3)Press down the main handle and check the indicator light. So we should just follow the direction of the light and rotate the micro-adjust knob until the middle light turns green.

Method2. 

If you don't have a shim momentarily, there is another method you can apply.

1)To ensure accuracy, we can also use probes of the same specification on both sides.

2)Press down the main handle and rotate it to lock it. And you can utilize the probe and cutter of the machine for key alignment.

3)Replace the cutter and adjust the micro-adjust knob until the middle light turns green.

Okay, now we've finished the height level adjustment of Condor XC-002 PRO.

Preparation

Before we start cutting, we need to take a look at the clamp. There are 3 marked positions at the bottom of the clamp: A, B, and C.

1. Slide in the clamp and make one triangle directs to the line depending on your need.

2. Then turn on the power switch of the cutter and adjust the speed control knob to a suitable speed.

Key Cutting

After getting everything ready, now we can start duplicating the key.

1. Press down the main handle and start cutting.

Now we've finished the one side of the key.

2. Turn off the power switch of the cutter. Clean up the clamp and flip the key.

3. Similarly, align the key and finish the height level adjustment of the other side.

4. Then turn on the switch to cut the key.

*Do not forget to turn off the power when completed.

Now we've finished the cutting and have a new HON66 key.

www.obd2shop.co.uk